MARCH PROMOTION 40% OFF & FREE SHIPPING

OPENING HOURS

Mon-Fri 9:00AM - 5:00PM EST
Background Image

Specifications

Printer

Pigment based Eco-Solvent 4pl
10 colors ink ( C, M, Y, K, Lc, Lm, Lk, Or, Rd + (optional) Wht or Mtl )
Nickel-free and a low odour UltraChrome GS3
1440 x 1440 dpi resolution
300dpi file processing

Material

6 mil auto Adhesive - repositional Vinyl
Emboss Linen wall Vinyl - Matte finish
Micro-Sphere adhesive offers clean release
Bubble free installation
Commercial Grade Extremely durable
Can be wrapped around corners or poles
Fire resistant (ASTM E84 Class 1)

What's included

Mural Print shipped in roll
Divided in strips of 35 to 45 inches ( overlap 0.5 inch on each sides except on the edges of the image )
Plastic Squeegee with protective side
Spirit (Bubble Level)
Manual

Installation

Tools required

  • Utility knife
  • Smoother, plastic scraper
  • Level
  • Lead pencil

    Recommendations

    This wall mural was designed for indoor use and is not recommended for outdoor use.

    The wall mural can be installed on a wide variety of smooth surfaces such as gypsum boards, wood, glass, metal and some plastics panels. However, it does not stick well to textured surfaces. Do not use on too textured paint, concrete or brick. Perform a test on a small area before proceeding with the installation.

    The installation surface must be clean, smooth, dry, in good condition and free of moisture, grease and stains.

    Remove the peeling paint or old wall coverings prior to installation.

    Preparation

    Use a damp cloth to clean dirt or dust from the surface, and let dry completely before installation. Do not use any chemical products.

    Manipulate the mural with caution in order to avoid creating creases or scratches on the printed surface.

    Remove all panels from the package. Check the number, order and direction and lay them down on the floor in the room a few hours prior to installation.

    Check that the sizes of the wall mural correspond to the height and width of the surface to be covered. Do not cut off the excess non-print on top and at the bottom of the panels as this will help to reduce the handling of the adhesive. WARNING: Most floors and ceilings do not form a perfect right angle to the wall; take into account before measuring.

    Determine the starting panel. For small surfaces, you can proceed from right to left or left to right. However, if the surface is very high (10 feet or more), it is recommended to start with the center panel.

    Using a level, draw a vertical line with a lead pencil. This line will guide the installation of the first panel.

  • Installation

    1. Roll the first panel so that the printed side is facing inward.

    2. Peel off a strip of 6" at the top of the Panel and cut off the excess of the protective paper.

    3. Carefully align the side panel with the line previously drawn and apply on the wall.

    4. To minimize deformations, always apply the wall mural with a minimum of tension. Slowly unroll the panel to the floor. Remove the protective paper from a few feet. Do not remove much at one time. Smooth the wall mural using a plastic scraper by performing movements from the center to the ends of the panel. Make sure it is straight and free of air bubble.
    If necessary, carefully remove the panel to release stubborn air bubbles or folds or use anything sharp (needle, tip of a knife) to pierce the surface and smooth with the scraper.

    6. Install the following panels using the same method as above. Panel joints should overlap at about 0.5" (12 mm). Align the image or pattern with the previous panel. Make sure that the ground is perfectly aligned to the eye. A small difference near the floor seems a lot less once the installation is completed.

    7. Once all the panels are installed, cut off the excess from the ceiling and the floor with a utility knife.

    Pictorem Facebook Like
    [[ «Success is 99 percent failure»  -  Soichiro Honda

    HOME 

    PRODUCTS
      CANVAS PRINT
      MURAL PRINT
     PHOTO PRINT
     ACRYLIC PRINT
     METAL PRINT
     PICTURE FRAME


    COLLECTION

    SUPPLIES
    FLOATING FRAMES
    GIFT CARDS
    INFO
    ABOUT US
    OUR PROCESS
    TESTIMONIALS
    SHIPPING INFO
    FAQ    |    GLOSSARY    |    WIKI
    MAILING LIST   |    PHOTO CONTEST


    FREE ONLINE SERVICE
    OIL PAINTING EFFECT
    IMAGE RESOLUTION ANALYZER
    DECORATION ADVICES
    IMAGE ON WALL GENERATOR

    PRO SERVICES
    PRO & RESELLER ACCOUNT
    AFFILIATE PROGRAM
    SELL PRINTS FROM YOUR WEBSITE



    ARTIST - SELL YOUR ART
    NEW ARTIST ACCOUNT
    LOGIN

    Never miss a great deal!
    SUPPORT
    CONTACT US
    MY ACCOUNT
    PRINTING RESOLUTION
    PRO RESOURCES
    UPLOAD
    McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams Shipping partners:  

    Pictorem Pinterest
    PICTOREM.COM - PHOTO TO CANVAS PRINTING       1-800-650-5301           MONTREAL, QUEBEC, CANADA      CHAMPLAIN, NEW YORK, UNITED STATES
    Sales terms & conditions - Privacy Policy - Site map